Posted by Janicholson on August 28, 2010 at 05:24:52 from (67.72.98.58):
In Reply to: Re: Super C Electricals posted by Tyler Jackson on August 26, 2010 at 16:14:59:
Three wire sizes are used. 0gauge for battery cables and an equal current carrying ground strap, 10 gauge from gen to reg, (or if an alternator, 10g from alt to amp meter load terminal) 10 gauge from amp gauge to starter switch or relay (connects to battery hot side), and 12 gauge for ignition, field wiring, and lights. Using 10 for all circuits other than bat cables would be difficult. Jim
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
