Posted by Tom Fleming on September 27, 2010 at 03:05:16 from (206.193.253.243):
Got to thinking about making a stock pulling tractor. I am not going to go spastic over souping it up. I want a solid build when I do it, but I am not going to go crazy with gizmo's.
problably will do the domed pistons, cam, head, and carb. That's it.
So, here is my question. Since the SM and the W9 are close in weight, seems to me the W9 would be a better platform to build from because of the HP / CID.
although, since the SM is a bit lighter, I could certainly get into at least 1 lower than 5500. So, the SM is more flexible on the HP to weight perspective.
A "setup" SM is a beast to beging with, but the W9 is definately a "get down and dirty "right out of the box".
This is kind of a "what if" question. Since I am not even sure if I am going to do this, thought I would post here before posting on the pulling boards. Thoughts?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Earthmaster - by Staff. This tractor, manufactured by the Earthmaster Farm Equipment company in Burbank, California was made for only two years. The Model C came out in 1948 and was followed by the "CN" (narrow-width model), "CNH (narrow-width high-crop model), "CH" (high-crop), "D" and the "DH" (high-crop) in 1949. The main difference between the models was tire size, tractor width and cultivating height. The "D" series were about 20 inches wider overall than the
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
