Posted by skycarp on November 05, 2010 at 09:12:58 from (208.93.180.75):
In Reply to: I Made A Mistake posted by Janicholson on November 04, 2010 at 22:23:43:
Jim and others,
Thanks for the comments and information. In looking at the I & T manual, I see the allowable side clearance for the compression ring is 0.001 - 0.0025, not .035. This doesn't effect me as I have new pistons and rings, but is is important to make corrections of any incorrect statements so that others won't make a mistake as a result of the erroneous statements.
I got the information on side clearance from the original service manual, which I do not have here at home now to check my earlier statement. But you are correct in the side clearance information.
I will try to find a set of top compression rings, or reorder a complete new set. A complete set of rings will cost me $44.00 plus shipping so this is a costly mistake.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Earthmaster - by Staff. This tractor, manufactured by the Earthmaster Farm Equipment company in Burbank, California was made for only two years. The Model C came out in 1948 and was followed by the "CN" (narrow-width model), "CNH (narrow-width high-crop model), "CH" (high-crop), "D" and the "DH" (high-crop) in 1949. The main difference between the models was tire size, tractor width and cultivating height. The "D" series were about 20 inches wider overall than the
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
