Posted by Ed Hill on November 08, 2010 at 19:48:59 from (66.113.63.232):
In Reply to: Re: T6 starter posted by Janicholson on November 08, 2010 at 18:36:02:
I do not have an original starter, prior owner put on the one I have but as I said the drive is not contacting the ring gear. Luckily the T6 has the inspection plate in the floor board so I could look in and found what is wrong. It turns the correct direction but when engaged misses the ring gear by one forth inch in front and also to the side. I am told the drives are not identified by number, just the complete starter. Thanks for your help. Just one little detail I have after a complete rebuild and restoration.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
