Posted by Janicholson on November 27, 2010 at 18:58:16 from (67.72.98.45):
In Reply to: Clutch and engine RPM posted by RD McClenahan on November 27, 2010 at 18:41:38:
there is a little less friction and lubricant viscosity in play with the pedal down, thus the tractor engine should have an easier time. If the cub has a graphite based throwout bearing, it could be gone with metal on metal in the housing. If it makes noise it probably is worn. If the Throw out bearing is a Ball style, it or the fork could be contacting the clutch Pressure plate. Again noise would be usually an indicator. The ball bearing could be seized and wearing the fingers. If it were mine I would adjust the clutch first (one and 1/2 inch travel befor it feels harder with hand pressure. If adjustment dis nothing, or it was close to correct already, I would split it to see what is going on. Jim
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Pitfalls of Tractor Engine Rebuilds - by Chris Pratt. The first pop after you have put the machine together with your own hands is exciting and pleasing. The whole experience can be marred if one moves too fast and makes too many assumptions that they can just use "as is" some parts they should be closely scrutinizing and possibly attended to. In such cases, rework makes what could have been a fun project turn into an irritant or even a nightmare. Minor Irritants To give you an example of an minor but irritating proble
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
