Posted by Larry B 1486 on December 30, 2010 at 19:20:35 from (67.142.161.22):
In Reply to: b 450 engine sleaves posted by MIKE BOCK on December 29, 2010 at 18:29:10:
I would give that webers tractor works a call first but the best I can remember thin wall sleeves from a MD not SMD will slip right in. A MD came out with a 3 7/8 bore but you could buy thin wall sleeves and increase the bore to 4" I looked up part numbers a few min ago after reading this, the MD and SMD break down the sleeve assy set and gives numbers for pistons ,pins , sleeves but the B450 parts book does not break it down. Just list part number for complete sleeve assy. I went thru this over 30 years ago with my B450. Used parts for these old tractors are very hard to find in my aera. I don't think that I have not seen a MD or 450 in salvage yards sence the early 1990's. I don't live to far from sikeston mo.where there are three good size salvage yards there.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Pitfalls of Tractor Engine Rebuilds - by Chris Pratt. The first pop after you have put the machine together with your own hands is exciting and pleasing. The whole experience can be marred if one moves too fast and makes too many assumptions that they can just use "as is" some parts they should be closely scrutinizing and possibly attended to. In such cases, rework makes what could have been a fun project turn into an irritant or even a nightmare. Minor Irritants To give you an example of an minor but irritating proble
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
