Posted by Bud DeLong on January 04, 2011 at 18:38:34 from (64.12.116.73):
In Reply to: Original F20 manifold posted by U.P. John on January 04, 2011 at 18:21:25:
Real close to fifty years ago Sid on the next farm had me take our F-20 over to tow their hard starting F-20. At first they tryed the little Ford but it would not tow the larger tractor! After towing a while with our 20 and no results i offered to belt them up! Worked good as you could pull the choke,fiddle with the mag and think it helped! Tryed priming it with the cups and it would hit a little. Gas would run out of the carb when you pulled the choke but no suction was found on the air inlet?? Got to feeling arround and found a pice of the intake manifold had rusted out on the back side!!!! Good luck on finding a org Hot manifold!! Bud.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Cletrac General GG and the BF Avery A - A Bit of History - by Mike Ballash. This article is a summary of what I have gathered up from various sources on the Gletrac General GG and the B. F. Avery model A tractors. I am quite sure that most of it is accurate. The General GG was made by the Cleveland Tractor Company (Cletrac) of Cleveland, Ohio. Originally the company was called the Cleveland Motor Plow Company which began in 1912, then the Cleveland Tractor Company (1917) and finally Cletrac.
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
