Posted by Haas on January 11, 2011 at 10:32:56 from (75.216.98.237):
In Reply to: Air Impact Wrench posted by Devin Arends on January 10, 2011 at 19:17:25:
Most impacts under $125 will not do large rusted bolts. The cheaper ones that say they have 250 ft-lbs of torque will barely do a 3/8 inch bolt. I'm using a Sears at present it is supposed to do 600 ft-lbs and it is strong enough to strip the threads on a fine thread 1/2 inch bolt. However, the sears has had some other issues with the trigger mechanism so if I get another, it will likely be an IR. I'm talking about 1/2 inch drive impacts here. Even the strongest 1/2 inch drive impacts may not do much with a 3/4 inch rusty bolt.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.