Posted by Tom Fleming on January 23, 2011 at 05:04:42 from (67.20.243.240):
In Reply to: Overflow tube posted by Garold Bliss on January 22, 2011 at 22:18:13:
couple of quick notes. The F-20 is NOT pressurized, it is thermosyphon. secondly, the overflow is soldered into the tank, or at least that is how I did mine. I used either 5/16" or 3/8" (can't remember) steel brake line to redo my rad.
I am a bit confused about the "thread" question. I will have to measure the protrusion I used on my tank. If I were to estimate, I would say 2", but I really would like to measure. My F-20 is stored for the winter, and I won't be there for a week or two.
I am sure that Nebraska Cowman or 36F30 can answer off the top of their heads, or someone can check.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulic Basics - Part 2 - by Curtis Von Fange. In the last entry to this series we gave a brief overview of hydraulic system theory, its basic components and how it works. Now lets take a look at some general maintenance tips that will keep our system operating to its fullest potential. The two biggest enemies to a hydraulic system are dirt and water. Dirt can score the insides of cylinders, spool valves and pumps. Wate
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
