Farmall & IHC Tractors Discussion Board |
some guys know a lot. re Charlynn pump seal.
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Rod Hergott on July 11, 2000 at 20:32:21 from (206.75.182.64):
Several months ago I asked the board if they knew what the seal number was for the front shaft on a Charlynn pump. Low and behold someone gives me a seal number. I bought the seal but then decided to pay professionals to install it. They told me the seal I bought was the wrong one first of all but when I went back they told me that my seal was the right one (Too bad they charged $200 for putting it in) Any way, I want to thank the fellow that took the time to look up the correct seal number. Its guys like that that make this a great board. I could go on a long time talking about all of the other help I've had from the board but most of you have probably experienced the same thing.
Follow Ups:
Home
| Forums
Today's Featured Article -
Fabrication (Who Me? Make it myself?) - by Chris Pratt. First of all, what are the reasons for not fabricatin your own parts? Most judgements on what should be purchased rather than fabricated stem from: Originality - If the tractor restoration is to be 100% original, it is likely that you should spend the time and money to locate the component in the used or New-old-stock market. Since this can be extremely difficult, you may want to fabricate the item or purchase a modern replacement temporarily, but eventually, you s
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|