Posted by Bob M on February 09, 2011 at 08:13:17 from (67.240.171.41):
In Reply to: UD-16 posted by d282 on February 09, 2011 at 06:13:06:
Not a lot of UD-16 engines were made. Consequently I'd anticiapte parts will be very hard to find.
Now I believe the UD-16 is essentially a UD-9 with 2 additional cylinders. Consequently it should share many internal parts with the UD-9/WD-9/TD-9 family. However even these are rather difficult to obtain.
If the one you are looking at doesn't turn over all the way I'd offer only scrap value. Or perhaps a bit more if it has sheet metal, injection pump, distributor/mag, carburetor, etc. that might be salvaged.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
