O.K I just pulled the carb again. It's been a while since I had done that. i tore it down and it looks very good, all brass in intact and in good condition. I double checked all passages with a lite, super thin wire, and air nozzle. all are free and clear. This carb is realativly simple as carbs go. I really think its good. the throttle shaft is just a little,little bit tight ( it wont flap around on its own when you shake the carb )It doesnt take real pressure to move it but it feels a little raspy? What is the point setting supposed to be .013 or .020 or better yet what is the proper dwell? It has a distributor not a mag. I didnt mean to scare anyone about the acid cleaning you can be certain I used it just sparingly enough to get done what needed to be done. After looking at it I am sure all cuel and air circuits are clear and in good cond. I really appreciate the feedback. 2 or 3 or more heads is better than 1. I know it's going to turn out to be something small and stupid!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Identifying Tractor Noises - by Curtis Von Fange. Listening To Your Tractor : Part 3 - In this series we are continuing to learn the fine art of listening to our tractor in hopes of keeping it running longer. One particularly important facet is to hear and identify the particular noises that our
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
