Posted by Tom in Iowa City on February 15, 2011 at 14:46:16 from (173.26.136.154):
In Reply to: Re: 22-36 posted by rustred on February 15, 2011 at 14:37:02:
Rustred, You say "have the machine shop build them up." Some concerns here: welding may or will soften the shaft, which would need to be rehardened, I suppose and probably no problem. Different kinds of weld material as to hardness. Probably an expensive operation. Also, hard to build up the inside of the transmission connection with welds. Don't know how practical this machine shop idea would be. Making a new shaft is out of the question, as to expense. Getting a used shaft would probably bring up a similarly worn one, if you can even find one. Do you think I would be best off leaving it as is and, knowing that it will not be put to work in the field and will probably not have too much running use? I'm getting close to feeling that doing nothing to it might be best? Agree? Thanks, Tom
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Harvestin Corn in Southern Wisconsin: The Early Years - by Pat Browning. In this area of Wisconsin, most crops are raised to support livestock production or dairy herds in various forms. Corn products were harvested for grain, and for ensilage (we always just called it 'silage'). Silo Filling Time On dairy farms back in the 30's and into the first half of the 40's, making of corn silage was done with horses pulling a corn binder producing tied bundles of fresh, sweet-smelling corn plants, nice green leaves with ear; the
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.