Posted by Brownie 450 on February 15, 2011 at 18:28:11 from (66.43.241.198):
In Reply to: 22-36 posted by Tom in Iowa City on February 15, 2011 at 14:17:39:
Looks like the shaft splines are the ones which are worn--right? If so, I'd take a mig welder & go down the worn side of each tooth maybe an inch at a time to avoid large heat build-up problems. Then--depending what you can get for equipment--cheap--use a mill or even an angle grinder in a jig to flatten/ shape the welds to fit the hub. I'll see if my brother would volunteer his mill to cut the welds. He has a Cinncinati. I take it the shaft is on the order of 4-5 feet long. We're housed up over here 30 miles East of you, so distance isn't the problem. Any one else on here please chime in with any suggestions. This outfit probably isn't going to be in any traction contests, so just taking most of the slack out ought to help.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Harvestin Corn in Southern Wisconsin: The Early Years - by Pat Browning. In this area of Wisconsin, most crops are raised to support livestock production or dairy herds in various forms. Corn products were harvested for grain, and for ensilage (we always just called it 'silage'). Silo Filling Time On dairy farms back in the 30's and into the first half of the 40's, making of corn silage was done with horses pulling a corn binder producing tied bundles of fresh, sweet-smelling corn plants, nice green leaves with ear; the
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.