Posted by Tom Fleming on February 16, 2011 at 04:09:14 from (67.20.243.240):
In Reply to: Super A timing posted by CNKS on February 15, 2011 at 17:27:56:
CNKS, are you sure that the crank, cam, and govenor gears are correctly timed? I had an issue with my A where the govenor was out of time to the cam gear.
If these are not correct, you have a bigger issue. The govenor gear is easy to correct, you only have to take the govenor cover off and the distributor/magneto. if the cam gear is not timed correctly to the crank, you are back to removing the front cover..........
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.