Posted by Ron-MO on February 17, 2011 at 06:59:51 from (24.177.135.98):
In Reply to: Barn Fire posted by bobthetoolguy on February 17, 2011 at 04:08:51:
A few parts might be salvaged, but restoring the tractor would be a huge effort, and a good many of the parts would have to be scrapped due to either cracks, or change to the metal structure properties (but I am no engineer). Some of the sheet metal might be salvageable if not warped, and gotten out of the weather to prevent massive rust damage. I know where I used to work we had a small heat treat furnace and it was used many times for stripping paint off sheet metal parts (unofficially). Basically burning off the paint, cooled slowly, then washed and repainted. Well ventilated of course. I know this fire was accidental, but I know if that was my barn I would be seeing an attorney holding supporting documentation of value of the barn and contents. I often burn off my fields, and am always reluctant as even though I have no neighbors close I always imagine what "could happen" if it were to get away from me or the wind pick up. The bad part is the lawyer will be the only one to really gain from it.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Trenching With a Plow - by Staff. Introduction: This interesting information came from one of the discussion forums here at YT. We thought we should place it up front so it could be read by anyone interested in putting old iron to work. [Editor] I tried something new today, and it worked so well I thought I should post it - in case it might help someone else. I'm running 100 yards of 4" drain pipe from the gutter downspouts of our house to a pond down the hill. This should hel
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
