Farmall & IHC Tractors Discussion Board |
Re: Serial # on IH Super C
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Under left foot on July 19, 2000 at 09:32:03 from (63.253.192.80):
In Reply to: Serial # on IH Super C posted by Ken in MI on July 18, 2000 at 03:54:25:
Ken: There are codes cast into major cast iron parts such as the top deck over the tranny, clutch housing and rear end that most likely are from the original. These codes have three parts. First two sets are month\year and last is a letter. The letters start with R being 1948, S being 1949 etc ..U would be 1951 if I counted right. So look under your left foot just behind the clutch. Whats is the three part code? Guy Fays DATA book is great for this and its only about $10. Over 50 years there can be mix and match on any machine. There are also many other minor changes. Disk brakes are a quick Super C item to check. good luck..harvey
Follow Ups:
Home
| Forums
Today's Featured Article -
Trenching With a Plow - by Staff. Introduction: This interesting information came from one of the discussion forums here at YT. We thought we should place it up front so it could be read by anyone interested in putting old iron to work. [Editor] I tried something new today, and it worked so well I thought I should post it - in case it might help someone else. I'm running 100 yards of 4" drain pipe from the gutter downspouts of our house to a pond down the hill. This should hel
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|