Farmall & IHC Tractors Discussion Board |
Splitting a Farmall 300 Narrow Front
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Paul Frey on July 19, 2000 at 10:17:25 from (164.227.201.20):
Last year I had it apart up front, and I renewed the seals there. This has only magnified the leaking at the other end, so with the years mowing behind me, I want to replace the rear main seal and the freeze plug on the rear of the engine. Any recommendations on supporting the two sections. I was planning on building a oak carriage/stand (approximately 6' wide at the base) to bolt to the frame rails for the front end, and a similar carriage on caster wheels bolted to the sides of the bell housing. Any ideas, experiences or reccomendations
Follow Ups:
Home
| Forums
Today's Featured Article -
Talk of the Town: The Saga of Grandpa's Tractor - by The following saga is from the Tractor Talk Discussion Forum. Someone. The saga starts with the following message: Hey guys I have a decision to make. I know what you all will probably suggest and it will probably agree with me way down inside, but here it is. I have a picture blown up and framed in my "tractor room" of a Farmall M. It was my Grandpa's tractor, of which whom I never got to meet. He froze to death getting this tractor out of the barn to pull a truck out of the ditch before I was born. Anyway my dad and aunt had to sell it at the auction,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|