Posted by toro in texas on April 06, 2011 at 19:50:46 from (67.216.252.175):
In Reply to: farmall 504 posted by reinclark on March 31, 2011 at 14:25:40:
I checked all four cylinders on my my 504 with the C153 and got reading on each cylinder around 150 psi. My C153 was giving me fits too as the previous owner either didn"t care or was clueless. It was amazing how much more power she had after a serious carb cleaning and kit. I also recommend using an inline gas filter along with cutting the gas off with a manual valve prior to the carb after tractor use. Another fun thing to watch for on the C153 is lose of oil pressure for the oil pump"s bottom plate warping. If you have low oil pressure this would be an area to check. Reasonabally easy fix but irritating from a engineering reliability aspect. Hind sight is 20 20. Additionally I utilized this forum"s archive to gain knowledge. Good luck.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Trenching With a Plow - by Staff. Introduction: This interesting information came from one of the discussion forums here at YT. We thought we should place it up front so it could be read by anyone interested in putting old iron to work. [Editor] I tried something new today, and it worked so well I thought I should post it - in case it might help someone else. I'm running 100 yards of 4" drain pipe from the gutter downspouts of our house to a pond down the hill. This should hel
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
