Posted by Westro on May 02, 2011 at 08:46:00 from (137.100.121.30):
I have a 1964 IH 706 gas that is in need of a rebuild. Front 4 cylinders are 160 psi rear two are 90 and 55.
So I popped the head, head and valves look 'good' what I am noticing is that there are head and piston markings like the rings have let go on #1, #5 and #6. I need to push the pistons out and take a look yet but what is my best plan of attack? I believe I would like to do a complete rebuild but I have never pulled sleeves from a motor like this? How are you guys pulling the sleeves. Looks like the site here has a rebuild kit that would fit the bill and is reasonable priced. Thanks for your response.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
