Posted by FarmallJon on May 10, 2011 at 17:34:00 from (72.224.243.66):
Hello all, I'm finishing up my restoration of my 1949 H. I bought a reproduction front "nose emblem" from ebay. It is made of aluminum, and looks pretty nice. The issue I'm having is that the emblem has straight sides....it is bent in the center, and each side is straight. The nose of the tractor is rounded, not straight. The emblem fits well right in the center, but since both sides of the emblem are straight and not rounded to follow the contour of the nose, the ends of the emblem are about 3/4" from touching the nose. Somehow, I have to bend some shape into each end of the emblem so it will lay back against the nose correctly. The problem is that the emblem is made from an aluminum "channel" and is quite resistant to being bent or formed. I'm afraid I will kink the top and bottom surfaces if I try to bend or form it backwards to the nose of the tractor. Anyone have any suggestions, or run into this before? Thanks in advance, Jon H.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Cletrac General GG and the BF Avery A - A Bit of History - by Mike Ballash. This article is a summary of what I have gathered up from various sources on the Gletrac General GG and the B. F. Avery model A tractors. I am quite sure that most of it is accurate. The General GG was made by the Cleveland Tractor Company (Cletrac) of Cleveland, Ohio. Originally the company was called the Cleveland Motor Plow Company which began in 1912, then the Cleveland Tractor Company (1917) and finally Cletrac.
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.