Posted by soybeanjoe on June 11, 2011 at 13:14:58 from (66.213.171.108):
In Reply to: acetylene transport posted by mike paulson on June 11, 2011 at 02:42:39:
As others have said, DOT regs call for them to be transported in the upright position. That said, I have seen a lot of them transported laying down.
I have a wooden rack that I transport them in the prone position in my p.u. bed that keeps them from moving. Been transporting them that way for over 40 yrs. Last spring was the first time I had an issue with the earth filler plugging the regulator. But I took the tank put of the truck & started using it without letting it stand for awhile. Cleaned the reg & everything was fine.
Use to be where we bought welding supplies made you sign a waiver of liability if you transported them horizonally but haven't done that for at least 10 yrs.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Trenching With a Plow - by Staff. Introduction: This interesting information came from one of the discussion forums here at YT. We thought we should place it up front so it could be read by anyone interested in putting old iron to work. [Editor] I tried something new today, and it worked so well I thought I should post it - in case it might help someone else. I'm running 100 yards of 4" drain pipe from the gutter downspouts of our house to a pond down the hill. This should hel
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
