Posted by metalmender11 on June 13, 2011 at 10:27:25 from (75.251.3.112):
I am in desperate need of some seal Part#'s for my 1940"M", I need the seal # for the shaft going into the transmission from the Clutch shaft, also need the seal# for the shaft seal coming out of the transmission that goes to the hydraulic pump,I am working out of town this week and called the dimensions I had into the bearing shop that I get my parts from but was told it is almost impossible to identify a seal byu the dimensions, I cannot get to the old ones to bring them into him as I said before I am working out of town, and the #'s were not legible, any help anyone could supply to me would be greatly appreciated
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.