Posted by rustred on June 14, 2011 at 21:28:28 from (72.172.100.113):
In Reply to: CLUTCH ADJUSTMENT posted by KEN IND. on June 14, 2011 at 20:56:59:
if i had no free playplay in the clutch i would not even think of doing any heavy pulling. thats the most important adjustment. just asking for trouble by slipping it. have anykind of free play is better than no freeplay. but if its slipping the damage may already be done, meaning clutch job. to adjust for freeplay adjust the clutch rod so you have about 3/4 to 1" between trans cover and clutch petal where it rests.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
