Posted by David(KY) on July 25, 2011 at 12:30:55 from (64.57.160.147):
I've got a 1964 international B414. Yesterday i was bush hogging when he pto went out, the pto handle was just hanging and not connected on the inside. I removed the 3 bolts and pulled it out and on the end there was a pin that had broke and allowed the one peace to turn and disconnect.I replaced the pin, but now i can't figure out how to connect it back again to the inside.Trying to work on it in the heat don't help,but i'm realy confused. Thanks for any help.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
