Posted by elroysdad on August 23, 2011 at 11:03:12 from (69.66.252.163):
In Reply to: F20 help please posted by elroysdad on August 02, 2011 at 05:50:11:
Got it going!!!!!!!!! After what seemed like a dozen times of timing the mag to the engine, pulling the tractor, trying to start with the belt pulley and everything else you could think of I found that I could get it to run with either numbers 1 and 4 OR numbers 2 and 3 wires hooked up. Would not run with all 4 even though each was getting a spark. It was then I realized that it must be carbon tracking inside the mag. I replaced what I thought was a decent looking rotor with a new one and cranked it by hand two times when it started and ran pretty well. I stood there shaking my head.... Thanks for the help and info on this. I really do appreciate it.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
