Posted by CNKS on August 29, 2011 at 18:14:15 from (216.144.104.128):
In Reply to: Hauling a Farmall M posted by WI-Ed on August 29, 2011 at 17:56:51:
You have to reverse one wheel. The only other way to get them on a car trailer, etc is to use the rear cast centers off a 400/450 with double bevel rims -- so I have read. As to weight, I hauled about 5300 lbs of 350 with a 7000 lb GVW car trailer last week with my GMC half ton and an equalizing hitch. Maintained 65 mph for 100 miles, but I was probably about 500 lbs overweight, not too good of an idea. If I had a 3/4 ton and a goose neck, I don't think I would trade it for a bumper pull.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
