Posted by noncompos on October 06, 2011 at 21:28:08 from (97.120.199.59):
Wauk produced a little BD 4cyl engine that's listed in Wauk lists as 31/4x4=133cid, same as a Wauk FC. I have two notes re' the BD: (1) a Wauk BD1J was in a McC-Drg #22 thresher (from some forum post I neglected to note); (2) a "Farmall Engine Valve Repair Guide" that referred to a Wauk BDA-1 XA engine was on EBay on 3-30-11 (that might've been meant to say BDA-1 AND XA, as Wauk XA's were used in some IH combines). Under Wauk usage at the time BD would ordinarily be the basic engine, and "1J" would be works code for accessories (ign, carb etc) variations. BDA would be an actual BD variation of some kind. Does anyone here have an IH ref book that shows: (1)whether the BD was used in Farmall tractors?? (some Wauk FLs and FCs apparently were); and (2) if the "Farmall" name was applied to equipment (threshers, combines) as well as to tractors?? Engine lists in my old parts catalogs list a "BD1" engine in the IH lists and a "BD" in the Wauk engine list, but entries are confused as to 3x4 and 31/4x4 (the same bearings and specs but bores not matching)!! This "BD" is probably NOT the later IH BD144 33/8x4 or BD154 31/2x4 Any comments appreciated!! Many thxx!! Bud
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: How to Remove a Broken Bolt - by Staff. Another neat discussion from the Tractor Talk Discussion Forum. The discussion started out with the following post: "I have an aluminum steering gear housing with a bolt broken off in it. The bolt is about a 3/8" x 1 1/2" bolt. I've already drilled the center of the bolt out with about 7/64" drill bit the entire length of the bolt. Only one end of the bolt is visible. I tried to use an easy out but it wasn't budging and I didn't want t
... [Read Article]
Latest Ad:
2022 John Deere 5045E, 4wd, front end loader and 3rd function with grapple. 120 hrs, 55k new, must sell
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
