Posted by FarrviewWest on November 02, 2011 at 14:35:35 from (165.206.209.230):
In Reply to: Blown manifold gasket posted by BAL@IN on November 01, 2011 at 10:30:30:
I took my manifold to Midwest Cylinder Head in Nevada, IA and they milled the surface completely flat for $36. The manifold and head now mate up perfectly! Of course the head was milled too when I took it in for a rebuild...I don't think I could have doubled up on gaskets and make mine leak free. The problem was that the manifold just wasn't flat and no matter how much i tightened the nuts onto the studs, it would still leak.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
