Farmall & IHC Tractors Discussion Board |
Re: To Settle an Argument
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Glenn on August 27, 2000 at 14:28:38 from (209.253.184.84):
In Reply to: To Settle an Argument posted by Wardner on August 26, 2000 at 20:54:02:
This is what we were taught in college(FWIW): Think of electricity traveling through a wire like water traveling through a pipe. Voltage can be considered the same as water pressure in the pipe. Amperage can be considered equivalent to volume of water in the pipe, and wattage can be considered the same as the amount of work a given amount of electricity(wattage=voltage x amperage) can d(like water going over a waterwheel). That being said, a battery can make 12v(pressure) but not have enough volume of current(amperage) to do the work. Consider a waterwheel: you could have water at 100 PSI(voltage) coming out of a 1/2-inch pipe(volume) flowing over the wheel; while the pressure is high, the total water volume is so low(amperage) that it cannot turn the wheel due to the wheel's size. However, a large amount of water(like a steady-flowing stream or creek) can turn the wheel in spite of the low pressure because the sheer volume of water makes up for the low pressure. This is a very simplified example, but it gets the point across. This is also why a 6v system must receive regular maintenance to be able to do its job, as pointed out by the other posters. Since a 6v system has lower pressure(voltage) to begin with, it must be maintained to keep the volume(amperage) of the electricity high enough to turn the starter(i.e. waterwheel). Hopefully, I didn't bore you with this tome!
Follow Ups:
Home
| Forums
Today's Featured Article -
Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|