Posted by pete 23 on November 03, 2011 at 17:26:48 from (74.32.238.142):
In Reply to: H Cylinder Bore posted by Jim Paterson on November 03, 2011 at 17:15:32:
Normally the bore size is referring to the inside dia of the bore with sleeve installed. Standard from factory was 3 3/8th and over bore is the thin wall version of the sleeve and is 3 7/16th which is what is available today. The original sleeve was about 1/8th inch thick and the thin wall is about 1/16th inch thick. I don't know the actual size of the block bore without a sleeve installed. Not sure it is even in the service manual, might be.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
