I ran one on a Cub with an IH right angle adaptor for a number of years. Only used it for wood less than 6" diameter although it could handle bigger. It was easier to buck the big stuff with a chainsaw where it lay rather than hump it over to the tractor.
When I bought it, I was told it was a "man-killer". Presumably, someone died while using it. The most important safety issue is to move the tractor when the wood pile gets large. It is important to reduce the tripping hazard around that spinning blade. Oh yeah, wear tight fitting clothes, too.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.