Posted by Dan-IA on December 07, 2011 at 16:24:13 from (66.43.223.5):
I'm working with Dad's tractor. Dad entered into the deep sleep on november 6, and I'm trying to slap my 8-foot lundell snowblower on the back in preparation for winter.
But the lower swing arms are too far down, and I had to raise them as high as they went just to put the lower pins in. That won't lift the blower.
But that's easy, I just have to take the upper swing arms loose off the splined shaft (rockshaft) above, start the tractor, let the tractor roll the rockshaft back to the lowered position, and put the arms back on the rockshaft.
That should be easy. A little bit of using real muscle, like I rarely get to use in town, but I got it done.
Or so I thought. Now the lift arms don't move at all. What did I do wrong? Only thing I can think of, I did notice that the rockshaft did slide about a 1/4" to 1/2" left or right while I was taking the arms off. Did I get something out of time inside, introduce air to hydraulics, or blow a seal? I don't know how the rockshaft stuff works.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Farmall M - by Staff. H so that mountable implements were interchaneable. The Farmall M was most popular with large-acreage row-crop farmers. It was powered by either a high-compression gas engine or a distillate version with lower compression. Options included the Lift-All hydraulic system, a belt pulley, PTO, rubber tires, starter, lights and a swinging drawbar. It could be ordered in the high-crop, wide-front or tricycle configurations. The high-crop version was called a Model MV.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
