|
Farmall & IHC Tractors Discussion Board |
Mounting aux. hyd. pump on Int'l. 404
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Mark Correll on September 01, 2000 at 17:49:02 from (12.76.118.115):
I have a 1961 International 404 and I would like to mount a New Idea loader that I have on it. The problem is that the loader has high pressure cylinder (it came off of an A-C). I work for a pump and valve mfgr. and can buy a high pressure pump very cheap instead of buying expensive cylinders. It appears that there is a coupling bolted tothe front of the crank pulley and there is a clearance slot in the steering box that is in front of and slightly below the engine. I believe I can mount a pump in front of the grille onto a bracket using a shaft and flexible coupling to drive the pump. Does anyone know if there was ever such an option and if the bracket may be available from International?
Follow Ups:
Home
| Forums
Today's Featured Article -
Talk of the Town: How to Remove a Broken Bolt - by Staff. Another neat discussion from the Tractor Talk Discussion Forum. The discussion started out with the following post: "I have an aluminum steering gear housing with a bolt broken off in it. The bolt is about a 3/8" x 1 1/2" bolt. I've already drilled the center of the bolt out with about 7/64" drill bit the entire length of the bolt. Only one end of the bolt is visible. I tried to use an easy out but it wasn't budging and I didn't want t
... [Read Article]
Latest Ad:
2022 John Deere 5045E, 4wd, front end loader and 3rd function with grapple. 120 hrs, 55k new, must sell
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
