Posted by JRSutton on December 12, 2011 at 05:32:31 from (75.130.109.233):
In Reply to: Painting Cast Iron posted by Bob M on December 11, 2011 at 15:44:14:
Overall, yes, just painting with a brush can be much quicker and easier.
But my point was a personal perspective on the fact that the actual monotonous WORK time is much longer with a brush. And with my A.D.D if I'm five minutes into it with a brush, I'm bored out of my skull and WILL just get messy for the rest of the job.
I'll start over applying and slobbering paint everywhere leaving lots of runs and drips and pools of paint, start touching and bumping into everything, getting paint all over me, etc etc.
I'm much safer with a spray gun.
Again, a personal perspective, but I know I'm not the only person who's short on patience. And you do have to factor that in when evaluating whether or not you personally can do a good brush job.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Timing Your Magneto Ignition Tractor - by Chris Pratt. If you have done major engine work or restored your tractor, chances are you removed the magneto and spark plug wires and eventually reached the point where you had to put it all back together and make it run. On our first cosmetic restoration, not having a manual, we carefully marked the wires, taped the magneto in the position it came off, and were careful not to turn the engine over while we had these components off. We thought we could get by with this since the engine ran perfectly and would not need any internal work. After the cleanup and painting was done, we began reassembly and finally came to t
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
