Josh, I did a lot of plowing with a 400 and a 311 plow years ago. First thing I did was remove the pins from the fast-hitch as mentioned earler. Then I set the cylinder stop to limit how much the plow could drop. Finally I set the gauge wheel so it would mainly hold the plow at the depth I wanted. Basicly the depth was controlled by the gauge wheel. Only other thing I would do in hard ground is slightly set the tilt cylinder downward monmentary when dropping the plow. But your 350 don't have this cylinder. Still have the plow and only use it to plow the garden with my 350 FH. It seems to work OK on it too, but I always use the gauge wheel. Al
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Identifying Tractor Noises - by Curtis Von Fange. Listening To Your Tractor : Part 3 - In this series we are continuing to learn the fine art of listening to our tractor in hopes of keeping it running longer. One particularly important facet is to hear and identify the particular noises that our
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
