Posted by Mike1972chev on February 11, 2012 at 06:26:21 from (99.50.229.230):
Probably more of a question I should be asking in the "tractor pullers" forum???I have seen this asked,but CANNOT find it on here. Farther down this post,I see where it is talked about what hubs adapt pressed steel wheels to the rears.I see where Oliver adapters work,I see M&W made them (PRICEY on EBAY !!!!)Did anybody else make a clamp on style hub to bolt on rears.
Now the front hubs:I hear of guys using front hubs and wheels off of a cub to get the pressed steel wheels????(Is this right???)Or what other Farmall hubs that use a bolt on steel wheels with a 5 or 6 bolt pattern can be used???? Is this a "bolt on" with a bearing change,or something???
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.