|
Farmall & IHC Tractors Discussion Board |
Re: 300U PS Hydraulic System
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Wardner on September 12, 2000 at 20:45:03 from (63.23.216.117):
In Reply to: 300U PS Hydraulic System posted by George on September 12, 2000 at 19:32:30:
I hope the guy that sold you your parts took everything off of one tractor and did not try to assemble the system from used parts on a shelf. The flow control valve is special and that goes for the valve that fits next to the manifold/stand/housing (whatever you want to call it). There are probably 4-6 different valves and I cannot see that they are identified with part numbers. It takes an expert to know the difference. They were used for 7-8 years on probably 20 different systems. I am not familiar with the 300 U but I did retrofit a PS on a Farmall 400 last year and it wasn't easy. Another poster on this board last winter was doing exactly what you are doing now. I recall he had problems with the U-pipe as well. Check the archives. Just reread your post and decided to send this picture. It is the 400 PS Hydra-Touch. You will notice that there is no plate. An SAE O-ring right-angle fitting x JIC (I think) screws into the valve. I hope you have a parts book.
Follow Ups:
Home
| Forums
Today's Featured Article -
Product Review: Kreem Brand Fuel Tank Liner - by Staff. This condition has occurred on a few machines that we have had and fortunately we were able to borrow the technique used at the local motorcycle shop. The product that we have used is called Kreem thouh there are others on the market, this one was recommended and available. This particular product is sold in three parts, a bottle of etch, dryer, and sealer. We were fortunate enough to start the process with stern warnings from those that had used this type of product before. The horror
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
