Posted by pete 23 on April 11, 2012 at 10:29:29 from (74.32.231.176):
In Reply to: 1026 Hydro Surging posted by Curtisk84 on April 10, 2012 at 21:07:30:
Had this happen on a 186. Under not load, road speed and after checking all things I felt might cause this,I just set the speed of engine down as it was over speeding and that took care of the problem. I felt I was getting plate lift off from the excessive rpm's. I know that usually happens when plates get worn and under heavy load or coast but I just could not find any other reason under the circumstances and it worked fine after that. It didn't take much rpm reduction and it still was within specs at no load.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
