Posted by LarryM on April 16, 2012 at 19:56:06 from (76.210.70.226):
A few years ago my Dad aquired an M that had been used a lot but taken very good care of. The Governor was completely wore out. I had an H engine that I bought that had the original cast iron psitons in it and the original governor hanging on the side. I was pretty tight yet. We changed the gear. We had enough parts around to change the top with very tight parts. The tractor is running stock 1600 high idle RPMs. We put it on the dyno and it has 55hp at 540 pto. When we pull it down to 500 pto it only goes up to 56hp. I have never seen a Farmall hit max hp at 540 PTO. As far as I can tell the M & H governor weights are identical. I have never seen a factory governor perform this well. This caused me to go Hmmmmm. Are the factory Governors that good when they are new? Is the difference in the spring? I am attempting to understand these governors better so any help is greatly appreciated.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Farmall 460: That's My Girl - by LeAnn R. Ralph. How many sounds can you think of that are as familiar to you as your own breathing? What about the hum of your refrigerator? Or the thump of your clothes dryer? Maybe the engine of your car? You hear those sounds every day, and you don't think much about them, do you. I can think of a few common, ordinary sounds in my daily life, too.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
