Posted by mkirsch on April 18, 2012 at 05:41:27 from (64.80.110.75):
In Reply to: cultivator on b farmall posted by jerry standerfer on April 17, 2012 at 10:26:21:
Jerry, a picture is worth 1000 words. It's hard to help without really knowing what you're working with.
We can also take your picture, and draw out what you should do using a paint program... At least those of us with any artistic ability.
In a nutshell, though, you need to identify the "pushrod" that lifts the cultivators, and replace that with a hydraulic cylinder. Sometimes there's room to install the cylinder directly, sometimes not.
You'll probably need to fabricate an anchor point that's attached to the body of the tractor for the cylinder to push off.
You won't need a very large cylinder, or a very long one. If the cultivators lift separately on each side, the ideal situation is TWO cylinders, but you can also rig up some sort of mechanism
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: How to Remove a Broken Bolt - by Staff. Another neat discussion from the Tractor Talk Discussion Forum. The discussion started out with the following post: "I have an aluminum steering gear housing with a bolt broken off in it. The bolt is about a 3/8" x 1 1/2" bolt. I've already drilled the center of the bolt out with about 7/64" drill bit the entire length of the bolt. Only one end of the bolt is visible. I tried to use an easy out but it wasn't budging and I didn't want t
... [Read Article]
Latest Ad:
2022 John Deere 5045E, 4wd, front end loader and 3rd function with grapple. 120 hrs, 55k new, must sell
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
