|
Farmall & IHC Tractors Discussion Board |
3 pt Hitch Linkage (806)
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Ken T on September 24, 2000 at 14:56:00 from (209.83.76.6):
I am not sure of the proper terms to use here, so please bear with me. The 3 point hitch assy on my 806 consists of two lower dead arms and two upper live arms. The live arms are connected to the dead arms by a linkage. It is this linkage that I want to talk about. The linkage consists of two main members. One screws into the other (acme threads). The purpose of the treads is so that the elevation of one arm can be adjusted relative to the other arm, thus leveling the implement. Anyway, I removed these linkages from my tractor because the threads were frozen solid from years of neglect. I intend to break the threads loose, sand blast and paint these links, then reinstall them. Currently the links are soaking in liquid wrench to make it easier for me to break the threads loose. My question has to do with how to prevent these threads from freezing up in the future. I see that there are two holes in the casting in the area of the threads. One is about 3/16" dia and the other is about 1/2" dia. I thought that the small hole might be for a grease zerk, but the hole is not threaded. Maybe it is for giving the threads some oil. I don't know what the larger hole is for. Anyway it seems like a big mess would be created in a short time if I use oil or grease on these threads. I don't really want to see them messed up after going to all the work of cleaning them up :). Can anyone tell me what the recommended maintenance procedure is for these threads to keep them working freely?
Follow Ups:
Home
| Forums
Today's Featured Article -
Timing Your Magneto Ignition Tractor - by Chris Pratt. If you have done major engine work or restored your tractor, chances are you removed the magneto and spark plug wires and eventually reached the point where you had to put it all back together and make it run. On our first cosmetic restoration, not having a manual, we carefully marked the wires, taped the magneto in the position it came off, and were careful not to turn the engine over while we had these components off. We thought we could get by with this since the engine ran perfectly and would not need any internal work. After the cleanup and painting was done, we began reassembly and finally came to t
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
