Posted by CenTex Farmall on May 22, 2012 at 22:26:33 from (166.183.187.52):
Got the 400D home and in the shop! Still working on it to get it to run on diesel. Still starts easy on gas.
I"ve pulled the filter system apart and couldn"t find any obvious blockage but some parts were plenty dirty. Going to clean out the whole thing and replace both filters.
Also pulled the lift pump off and I don"t see anything obviously wrong or bad looking. Checked from above and the rack seems to move freely back and forth.
The oil in the pump seemed to have a some fuel contamination. I assume there"s some leakage from the lift pump. Looking at the lift pump it seems like it would be straightforward enough to change the seal. Any tricks or surprises in there? Anyone know the part number for the seal? I tried looking on the CIH website but with no luck for pump parts.
The oil in the pump was also fairly black, like crankcase oil. Any chance oil is leaking into the pump from the crankcase? I know that will involve pulling the pump to change. Part number for that seal?
Lastly, is there a way to make sure the plunger is not stuck without dismantling the entire pump?
I"m working from a blue ribbon service manual that covers the MD and an I&T manual that covers the same. Not exactly the same pump but will probably keep me out of trouble. I"m planning to order the right ones for the 400 soon.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - When Push Comes to Shove - by Dave Patterson. When I was a “kid” (still am to a deree) about two I guess, my parents couldn’t find me one day. They were horrified (we lived by the railroad), my mother thought the worst: "He’s been run over by a train, he’s gone forever!" Where did they find me? Perched up on the seat of the tractor. I’d probably plowed about 3000 acres (in my head anyway) by the time they found me. This is where my love for tractors started and has only gotten worse in my tender 50 yrs on this “green planet”. I’m par
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
