Golly, thanks you guys.....I do have that very picture of the old clamps in an IH Implements for Super C tractor original catalog. I even called a dealer 90 miles from me with the square nuts part number, which superceded to another number, and surprisingly still avail. at about $1.20 each. I always have fun looking that stuff up. And the info about that bar from an A, or B, BN tractor - very interesting ! The weeder-mulcher has 39 teeth, which I did see mentioned in a catalog too, I found at a car junk yard, over the river bank, so rescued it and got it to use too...surprisingly all still flex pretty darn good, it is fun to watch working. I know it is a homemade little bar, but I hope to put new pieces of wood between the old iron braces, just to look good. Thanks so much for your input, just don't have anyone around here of similar interests in the old IH stuff, I think which should be saved, but does get discouraging ........ I really appreciate hearing from you all .....
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Cletrac General GG and the BF Avery A - A Bit of History - by Mike Ballash. This article is a summary of what I have gathered up from various sources on the Gletrac General GG and the B. F. Avery model A tractors. I am quite sure that most of it is accurate. The General GG was made by the Cleveland Tractor Company (Cletrac) of Cleveland, Ohio. Originally the company was called the Cleveland Motor Plow Company which began in 1912, then the Cleveland Tractor Company (1917) and finally Cletrac.
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
