Farmall & IHC Tractors Discussion Board |
Re: Mower Deck for Farmall A
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Haas on September 27, 2000 at 19:54:22 from (129.37.117.209):
In Reply to: Mower Deck for Farmall A posted by John on September 27, 2000 at 10:15:34:
If you are doing lawn mowing, the Super A will handle the 72 inch mower. I'm talking about a belly mower, such as made by Woods. I would not put a 72 inch mower on a Super A 3 point hitch. I think it would be too heavy and you would have problems with the offset PTO. If you go with a 60 inch belly mower, you can go through fairly tall grass in second gear. For the Woods mower, you have to have the belt pulley attachment, as the vee belt for the mower runs off that shaft. You don't need the flat belt pulley. I also assume you are talking about a Super A, not an A as the A did not have any hydraulic system.
Follow Ups:
Home
| Forums
Today's Featured Article -
Fabrication (Who Me? Make it myself?) - by Chris Pratt. First of all, what are the reasons for not fabricatin your own parts? Most judgements on what should be purchased rather than fabricated stem from: Originality - If the tractor restoration is to be 100% original, it is likely that you should spend the time and money to locate the component in the used or New-old-stock market. Since this can be extremely difficult, you may want to fabricate the item or purchase a modern replacement temporarily, but eventually, you s
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|