glennster said: (quoted from post at 20:53:43 06/08/12) i just painted a fuel tank for a 574 intl for a customer. he brought in the majic paint , primer,hardener and thinner. shoots the same as valspar, i used an hvlp with a 1.7 mm tip gravity gun. yeah, i know, its inexpensive paint. looks better than it did, and it dont make much sense to hang a new chandelier in a haunted house!!
Same here ... only I am using the Majik rattle can IH red for those odd little braces and hangers under the cover.
It reminds me of the old epoxy paint .. takes like 3-4 days to cure well but it does hold tight with good coverage.
Once I move onto the sheet metal and frame I will be far more critical and start using a loaded spray gun and hardener. I like the glossy shine it leaves.
This post was edited by TMonton at 20:45:10 06/08/12 2 times.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Farmall M - by Staff. H so that mountable implements were interchaneable. The Farmall M was most popular with large-acreage row-crop farmers. It was powered by either a high-compression gas engine or a distillate version with lower compression. Options included the Lift-All hydraulic system, a belt pulley, PTO, rubber tires, starter, lights and a swinging drawbar. It could be ordered in the high-crop, wide-front or tricycle configurations. The high-crop version was called a Model MV.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.