An M/H clutch has 6 bolts that you have to take out to remove the pressure plate. The three bolts that you put in take up the pressure from the pressure plate so it is easier to reinstall and put the tractor back together.
Sorry no B specific advice, but hopefully you can use some of the info.
Edit - Yeah, there are 6 bolts to take out to take the pressure plate off a B. Everything looks pretty similar to the big tractors. You have to take these out. Look at the parts diagram and you can see what is going on pretty well.
[quote:08eb3ca6bc] 6 179816 BOLT Hex, 5/16"-18 x 3/4", G5, Full Thd, BOLT, Hex, 5/16"-18 x 3/4", G5, Full Thd [/quote:08eb3ca6bc]
This post was edited by sflem849 at 12:37:12 06/10/12.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Farmall M - by Staff. H so that mountable implements were interchaneable. The Farmall M was most popular with large-acreage row-crop farmers. It was powered by either a high-compression gas engine or a distillate version with lower compression. Options included the Lift-All hydraulic system, a belt pulley, PTO, rubber tires, starter, lights and a swinging drawbar. It could be ordered in the high-crop, wide-front or tricycle configurations. The high-crop version was called a Model MV.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.