Well, the left one is trashed. The drain hole was plugged and it must have gotten water in it. There was moist rusty crud up to the hole where the yoke comes out. Every metal braking surface is covered with pits. Two of the three springs were rusted to pieces and the balls are junk. I am going to buy three new springs and throw it back together. It will be good enough to go pulling on Saturday. It is going to take a lot of time and money to make this thing like new again. I am assuming they don't make any of the metal pieces new anymore???
Did M&W make aftermarket brake components? The right hand brake had an M over a W casting mark on it. The left side was different.
I forgot to say that I was in there like 5 years ago to inspect/restore the brakes. I just cleaned everything up and put them back together. They have been fading slowly for the past couple years.
Here are some pictures.
This post was edited by sflem849 at 20:25:15 06/21/12 2 times.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Trenching With a Plow - by Staff. Introduction: This interesting information came from one of the discussion forums here at YT. We thought we should place it up front so it could be read by anyone interested in putting old iron to work. [Editor] I tried something new today, and it worked so well I thought I should post it - in case it might help someone else. I'm running 100 yards of 4" drain pipe from the gutter downspouts of our house to a pond down the hill. This should hel
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
