Posted by Matt E. on August 03, 2012 at 11:39:15 from (173.216.243.151):
In Reply to: 140 manifold posted by Matt E. on August 03, 2012 at 07:30:26:
I'm not sure if this is the IH gasket numbers but the 113-123 cid (A/B/C/100/supers/etc) call for #352014 R1. The 140 calls for #352014 R2.
I've looked at pictures of the gaskets and the 113 cid seems to have round ports on the inner two (I think the exhaust) and the 140 has square ports. My head has square ports on the inner two and round ports on the outer two on each side, like the 140 gaskets/manifold.
Some companies selling manifold gaskets (aftermarket) list it will fit a B (113 cid) as well as a 140.
The reason I ask is I'm looking at a used 140 manifold pretty cheap and I need one for my 1945 B 113. Most of the other used manifolds I've seen are just a little cheaper than a new one.
Mr. Bender, would you be able to clarify this? You seem to be the resident expert on 113/123 motors.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Engine Rebuild Kit - by Curtis Von Fange. I always liked engine rebuild kits. They have all the replacement parts for overhauling an engine without going to the store to get gaskets, special measuring tools, or miscellaneous parts. They come neatly packaged, clean and tidy. But it's important not to let that packaging lull you into a false sense of security. The appearance of matching sleeves, pistons, rings, and bearings can cause frustration and agony if not properly measured and installed in a workshop environment. Following c
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.