Posted by riverbend on August 05, 2012 at 17:52:42 from (74.46.187.121):
In Reply to: more horsepower posted by WVFarmall on August 05, 2012 at 14:08:21:
When I went through my H I replaced the kerosene head with a gas head. Used Fire Crater ( genuine IH ) pistons and had the cam reground to SH specs. There was a bunch of minor stuff like new springs in the distributor, rebuilt the governor, and some SH carb parts, but nothing too radical.
It made a very noticeable difference in power. It will out pull my 350 when plowing in 3rd gear. In all fairness I have to say I just bought the 350 and have not been through the motor, but it runs good and does not burn any oil. With (2) 16s, it will keep up with my neighbor's JD 70 diesel pulling (3) 14s.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Trenching With a Plow - by Staff. Introduction: This interesting information came from one of the discussion forums here at YT. We thought we should place it up front so it could be read by anyone interested in putting old iron to work. [Editor] I tried something new today, and it worked so well I thought I should post it - in case it might help someone else. I'm running 100 yards of 4" drain pipe from the gutter downspouts of our house to a pond down the hill. This should hel
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
